If there is a PWR indicator, you can check the indicator go off and on again.Click the reset button for at least 5 seconds until the camera restarts, and then the camera will be restored to factory default settings.The camera should be connected to power.Press and hold the reset button for 15 seconds.Upon successful restoration, the status LED will blink green and red during normal operation. All settings will be restored to factory default.Restore-Press and hold the recessed reset button until the status LED rapidly blinks.Reset-Press and release the recessed reset button.Use a pin or paper clip to depress the reset button.Note: If the device does not reset on the first try, turn your device back on and immediately hold the power button down for 12 seconds until the spinning white light in the front turns off.Continue to hold until Canary Flex reboots (youвЂ™ll see a white spinning light again).Turn the device off / hold the power button down for 12 seconds until the light in the front turns off (if it was on).Wait for the camera to reset to default.Press and hold the Reset Button for more than 10 seconds using a paper clip or thin object.With the power on, use a small pointed object to press and hold the reset button beside the navigation buttons for more than 10 seconds.Wait approximately one minute for the camera to finish the reset process and to reboot.After you have applied power, continue to hold the reset button pressed for about five seconds.Apply power to the camera while continuing to hold the reset button pressed.Obtain a plastic stylus or similar non-conductive device that you can use to press the button.The product has been reset to the factory default settings.The process is complete when the status indicator turns green. Keep the control button pressed for 15-30 seconds until the status LED indicator flashes amber.Press and hold the control button while reconnecting power.Release the button after three seconds.While continuing to hold the button, power the device.Using a straightened paperclip or similar tool, gently press and hold the firmware revert button.After powering the camera on, pressing and holding the INITIAL SET button for about 10 seconds can reset all the parameters to the default settings.The network camera resets to factory defaults and restarts after completing the factory reset.Keep the Reset button (SW1) pressed for about 2 seconds.Press and hold the Reset button (SW1) on the board with your finger while reconnecting the power.Switch off the network camera by disconnecting the power adapter.If the camera is not connected to DHCP server, the default IP address is 192.168.0.80.The camera has been reset to the factory default.Press and hold the reset button for 10 seconds and then release the button.New generation models include a physical recent button, including the MicroDome Duo and MegaVideo 4K. Note that many Arecont cameras do not have a reset button and must be defaulted via software, of failing that, returned to the factory. Using a pointed object, such as a pen, press and hold the reset button for 5 seconds or until the blue LED (underneath the camera module) lights up.The unit will start up with factory default settings automatically.This will take around 20 seconds from power up, then release the reset button.The red Power LED light will flash on for 3 second first, turn off for about 15 seconds, flash on for another second and turn off again.Reconnect the power cable while continuing to hold the reset button.Press and continue to hold the Reset Button (with a sharp tipped object, like a pen.).Switch off IP device by disconnecting the power cable.Press RESET about 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, IP address, port No., etc.

Hikvision camera password reset button